MIL-R-83516B
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-129 - Marking for Shipment and Storage.
MIL-STD-202 - Test Methods for Electronic and Electrical Component Parts. MIL-STD-883 - Test Methods and Procedures for Microelectronics.
MIL-STD-1285 - Marking of Electrical and Electronic Parts.
(Copies of these documents are available online at https://assist.dla.mil/quicksearch or from the Standardization
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia PA 19111-5094.)
2.3 Non-Government publications. The following documents form a part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract.
AMERICAN NATIONAL STANDARD INSTITUTE (ANSI)
NCSL Z 540.3 - Laboratories, Calibration, and Measuring and Test Equipment.
(Application for copies can be requested online at https://www.ansi.org or from the American National Standards
Institute, Incorporated, 11 West 42nd Street, New York, NY 10036-8002.) AMERICAN SOCIETY OF TEST MATERIALS (ASTM International)
ASTM D5948-96 - Standard Specification for Molding Compounds, Thermosetting.
(Application for copies can be requested online at https://www.astm.org or from the American Society of Test
Materials International, 100 Barr Harbor Drive, P. O. Box C700, West Conshohocken, PA 19428-2959.)
NATIONAL ELECTRICAL MANUFACTURERS ASSOCIATION (NEMA) MW1000 - Wire, Magnet.
(Application for copies can be requested online at https://www.nema.org or from the National Electrical
Manufacturers Association, 1300 North 17th Street, Suite 1752, Rosslyn, VA 22209.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between the text of this document and the references cited herein (except for related specification sheets), the text of this document takes precedence. Nothing in this document, however, superseded applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in accordance with the applicable specification sheet. In the event of any conflict between the requirements of this specification and the specification sheet, the latter shall govern (see 6.2).
3.2 Qualification. Relays furnished under this specification shall be products which are qualified for listing on the applicable qualified products list at the time set for opening of bids (see 4.4 and 6.3).
3.3 Materials. Materials shall be as specified herein. However, when a definite material is not specified, a material shall be used which will enable the relays to meet the performance requirements of this specification. Acceptance or approval of any constituent material shall not be construed as a guaranty of the acceptance of the finished product.
3.3.1 Plastic. Laminated plastic material shall conform to MIL-I-24768/1, MIL-I-24768/9, or MIL-I-24768/17. Molded plastic material shall conform to ASTM D5948-96. Cotton-filled or wood-flour-filled materials shall not be used.
3.3.2 Ceramic. Ceramic insulating material shall conform to the following requirements of table I.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business