MIL-PRF-83726/31J
Inches
mm
Inches
mm
.001
0.03
.300
7.62
.002
0.05
.312
7.92
.005
0.13
.625
15.88
.040
1.02
.930
23.60
.050
1.27
1.010
25.65
.062
1.57
1.025
26.04
.150
3.81
1.396
35.46
.156
3.96
1.446
33.73
.200
5.08
1.718
43.64
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Unless otherwise specified, tolerance is .010 (0.25 mm) for three place decimals and ± .03 (0.76 mm) for two
place decimals.
4. Terminal numbers shall not appear on the relay header and there shall be a legible circuit diagram on relay
which identifies each terminal location specified.
5. Gasket material: The gasket material shall be of such quality to ensure the relay meets all the performance
requirements of this specification. Silicone rubber gasket SAE-AMS3332, shore hardness
20 ±5 has been considered acceptable.
6. Terminal composition: The terminal composition shall be of such quality to ensure the relay meets all the
performance requirements of this specification. Gold in accordance with SAE-AMS2422 or
ASTM B488, Type 3; underplating: nickel, 50 microinches to 150 microinches thick; has been
considered acceptable.
7. External resistor: In accordance with MIL-PRF-55182 (RNC60HXXXXFS), is selected as follows:
REXT = ((T1/T0) 1) 100k
T0 = Minimum time
T1 = Required time
T1 < 10 T0
8. Terminal C2 is optional.
FIGURE 1. Outline dimensions and configuration of relay Continued.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business