MIL-PRF-83536/10C
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Unless otherwise specified, tolerance is .010 (0.25 mm).
4. There shall be affixed to the relay a legible circuit diagram that identifies each terminal location specified.
5. These relays are polarized monostable.
6. This relay shall not operate or be damaged by reverse polarity.
7. Permanent magnet drive consists of a permanent magnet with its flux path switched and combined with the
electro-magnet flux.
8. Applicable to horizontal flange mount only. The circuit diagram, manufacturer's PIN, and the military PIN shall
be marked on the near side. The remaining portion of the nameplate data shall be marked on the far side.
9. Applicable to horizontal flange mount only. Relays shall be marked with the manufacturer's name or CAGE
code, and date code. Marking shall be with the bottom of the print adjacent to the near side.
10. Socket pin terminals shall provide the operational, environmental, and interface characteristics to provide a
reliable interconnect to gold-plated contacts. Terminals and all track mount terminals shall be gold plated.
One system for gold plating that may be used is ASTM B488, type 3, class 1.25 with a nickel underplate of 50
to 150 microinches thick. The gold plating system shall enable the product to meet the performance
requirements of this specification and shall be approved by the qualifying activity.
11. Gasket shall provide a reliable seal between the relay and mating socket that will meet the environmental,
operational, and interface requirements of the relay with the mating socket. The gasket shall have shore
hardness 30 to 45, thickness .050 .005. Gasket material according to SAE-AMS-3332 has been considered
acceptable.
12. Back EMF (transient voltage): 42 V dc maximum.
13. JANTX or equivalent screened semiconductors or hybrid devices shall be used for internal coil suppression.
Relays using suppression devices shall continue to operate should the suppression circuit be in a failure
mode. Diodes shall have a peak inverse voltage of 600 V dc minimum.
14. Grounding pin applicable to track mount relay only.
15. Track mount knob, post, and base shall be 303 Cres nickel plated in accordance with McAir P.S. 13112 or
equivalent 100 microinches thick minimum. The latching pin shall be 303 Cres passivated or nickel plated in
accordance with McAir P.S. 13112 or equivalent 100 microinches thick minimum.
16. Track mount relay shall be capable of mating with M6106/4 "Bracket and Socket Assembly", configuration II.
The latching pin shall be capable of withstanding an axial pull of 35 pounds, in a direction away from the knob,
without degradation. The rotation of the knob mechanism shall be restricted such that the latching pins cannot
be placed on the side opposite the M6106/4 bracket cutouts.
17. Indicated terminal shall be identified with a contrasting bead.
18. Plane of critical motion for vibration and shock is Y-axis.
19. Gasket shall provide a reliable seal between the relay and mating socket that will meet the environmental,
operational, and interface requirements of the relay with the mating socket. The gasket shall have shore
hardness 30 to 45. Gasket material according to SAE-AMS-3332 has been considered acceptable. Silicone
rubber gasket is not supplied with track mount A relays.
FIGURE 1. Dimensions and configurations Continued.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business