MIL-DTL-83729C
FEDERAL STANDARD
- Screw-Thread Standards for Federal Services.
DEPARTMENT OF DEFENSE SPECIFICATIONS
- Choppers, Electromechanical, Hermetically Sealed, Single Pole, Double Throw, Break
before Make.
- Choppers, Electromechanical, Dust Tight, Single Pole, Double Throw, Make before Break.
- Choppers, Electromechanical, Hermetically Sealed, Single Pole, Double Throw, Break
before Make, Bracket Mount.
- Choppers, Electromechanical, Hermetically Sealed, Single Pole, Double Throw, Break
before Make.
- Choppers, Electromechanical, Hermetically Sealed, Single Pole, Double Throw, Break
before Make.
- Sockets and Accessories for Plug-in Electronic Components, General Specification for.
- Connector, Plug and Receptacle, Rectangular, Rack and Panel Solder Type and Crimp
Type Contacts General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
- Test Method Standard, Electronic and Electrical Component Parts.
- Marking of Electrical and Electronic Parts.
DEPARTMENT OF DEFENSE HANDBOOK
- General Guidelines for Electronic Equipment.
(Copies of these documents are available online at https://assist.dla.mil/quicksearch or from the Standardization
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.3 Non-Government publications. The following documents form a part of this document to the extent specified
herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract.
SAE International
- Connectors, Electrical, Circular Threaded, AN Type, General Specification for.
(Copies of this document is available online at https://www.sae.org or from the Society or Automative Engineers,
400 Commonwealth Drive, Warrendale, Pennsylvania 15096-0001.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between the
text of this document and the references cited herein (except for related specification sheets), the text of this
document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless
a specific exemption has been obtained.
3.
REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in accordance with the
applicable specification sheet. In the event of any conflict between the requirements of this specification and the
specification sheet, the latter shall govern.
3.1.1 Choppers not covered by specification sheets. The individual item requirements for choppers furnished
under this specification and not covered by specification sheets shall be as specified (see 6.2.2).
3.2 First article inspection. Choppers furnished under this specification shall be products which have been tested
and have passed the first article inspection specified (see 4.3).
3.3 Inspection of choppers not covered by specification sheets. Choppers furnished under this specification and
not covered by specification sheets shall be products which have been tested and have passed the inspection
specified in 4.4.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business