MS24168T
Inches .010 |
mm 0.25 |
Inches .328 |
mm 8.33 |
Inches 3.387 |
mm 86.03 |
.031 |
0.79 |
.625 |
15.88 |
3.500 |
88.90 |
.063 |
1.60 |
.688 |
17.48 |
3.687 |
93.65 |
.095 |
2.41 |
1.190 |
30.23 |
4.062 |
103.48 |
.138 |
3.51 |
1.560 |
39.62 |
4.282 |
108.76 |
.218 |
5.54 |
1.718 |
43.64 |
4.312 |
109.52 |
.250 |
6.35 |
1.750 |
44.45 |
5.272 |
133.91 |
.266 |
6.76 |
2.156 |
54.76 |
||
.297 |
7.54 |
2.312 |
58.72 |
||
.312 |
7.92 |
3.000 |
76.20 |
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Unless otherwise specified, tolerance is ±.031 (0.79 mm).
4. Coil and auxiliary terminals may use an additional flat washer for terminal seat.
5. Break all sharp edges and remove all burrs.
6. In the event of a conflict between the text of this specification and the references cited herein, this specification shall take precedence.
7. Referenced Government documents of the issue listed in that issue of the Department of Defense Index of Specifications and Standards (DODISS) specified in the solicitation form a part of this document to the extent specified herein.
8. There shall be affixed to the relay a legible circuit diagram that permanently and positively identifies each terminal location specified.
9. Cadmium or cadmium compounds are prohibited on external hardware. A transition period to non-cadmium
hardware is authorized for up to 1 year from the date of this revision.
10. Spring washer on drawing is a spring lock washer.
FIGURE 1. Dimensions and configurations - Continued.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business