MIL-R-39016-34 Relays, Electromagnetic, Dpdt, Low Level To 1.0 Ampere, 0.100-Inch Terminal Spacing

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7

MIL-R-39016/34F

ELECTRICAL DATA:

Insulation resistance: 10,000 megohms minimum, except the resistance between coil and case at high temperature shall be 1,000 megohms or greater. MIL-STD-202, method 302, test condition A.

Dielectric withstanding voltage:
	Sea level	Altitude
	V rms (60 Hz)	V rms (60 Hz)
Between case, frame, or enclosure, and between all
contacts in the energized and deenergized positions	500
Between case, frame, or enclosure and coils - - - - - - - -	500	300
Between all contacts and coils - - - - - - - - - - - - - - - - - - Between open contacts in the energized and deenergized positions - - - - - - - - - - - - - - - - - - - - -	500 350	All terminals to case
Between contact poles - - - - - - - - - - - - - - - - - - - - - - -	500

ENVIRONMENTAL DATA:

Temperature range: -65°C to +125°C.

Vibration (sinusoidal): MIL-STD-202, method 204, test condition D (20 g's). Contact chatter shall not exceed

10 microseconds maximum for closed contacts, and 1 microsecond maximum closure for open contacts.

Vibration (random): MIL-STD-202, method 214, test condition IG. Contact chatter shall not exceed 10 microseconds maximum for closed contacts, and 1 microsecond maximum closure for open contacts (applicable to qualification and group C testing only).

Shock (specified pulse): MIL-STD-202, method 213, test condition C (100 g's). Contact chatter shall not exceed 10 microseconds maximum for closed contacts, and 1 microsecond maximum closure for open contacts.

Magnetic inference: Applicable. Resistance to soldering heat: Applicable. Acceleration: Applicable.

PHYSICAL:

Terminals: See figure 1.

Terminal strength: 1 ± .1 pound pull.

Solderability: Applicable to all terminations except pin, plug-in. Terminal twist test: Applicable to wire leads.

Terminal, socket plug-in: Plug-in terminals shall provide the operational, environmental, and interface characteristics to provide a reliable interconnect to gold plated contacts. One system for gold plating that may be used is ASTM B488, type 3, class 1.25 nickel underplate 50 to 150 microinches thick. The gold plating shall enable the product to meet the performance requirements of this specification and shall be approved by the qualifying activity.