MS24184M
Inches .010 |
mm 0.25 |
Inches .625 |
mm 15.88 |
Inches 3.000 |
mm 76.2 |
.031 |
0.79 |
.750 |
19.05 |
3.347 |
85.01 |
.063 |
1.60 |
.969 |
24.61 |
3.672 |
93.27 |
.095 |
2.41 |
1.172 |
29.77 |
3.732 |
94.79 |
.125 |
3.18 |
1.438 |
36.53 |
4.692 |
119.18 |
.266 |
6.76 |
1.844 |
46.83 |
||
.312 |
7.92 |
1.875 |
47.63 |
||
.328 |
8.33 |
2.063 |
52.40 |
||
.453 |
11.51 |
2.847 |
72.31 |
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Unless otherwise specified, tolerance is ±.031.
4. Coil and auxiliary terminals may use additional flat washer for terminal seat.
5. Weight includes covers and barriers.
6. All test requirements of specification MIL-PRF-6106 apply except that off time for motor load shall be six seconds minimum and average contact voltage drop reading before tests shall not exceed .15 volt.
7. PIN MS24184-1 is inactive for new design after 10 December 1957.
PIN MS24184-D1 replaces MS24184-1.
8. Referenced Government documents of the issue listed in that issue of the Department of Defense Index of Specifications and Standards (DoDISS) specified in the solicitation form a part of this standard to the extent specified herein.
9. Cadmium or cadmium compounds are prohibited on external hardware. A transition period to non-cadmium
hardware is authorized for up to 1 year from the date of this revision.
10. Spring washer on drawing is a spring lock washer.
FIGURE 1. Dimensions and configurations - Continued.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business