MIL-R-19309 Relay, Sensitive For Torpedo Mark 37 Mod 2This specification describes the requirements for the acquisition of a double-pole, double-throw, sensitive electromagnetic relay, Drawing 1521140. The coil is rated at one watt at a voltage of 31.6 V dc. The relay is used in the control of functional circuits which operate on a nominal dc voltage of 25 volts and dc current up to two amperes.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14

MIL-R-19309D

4.6  Functional tests.  At the conclusion of the tests specified in 4.4.1.4 and 4.4.2 above, functional and other tests, as applicable, shall be conducted on the relay to determine freedom from operational malfunction and compliance with all performance requirements and product characteristics of this specification.

5.  PACKAGING

5.1  Packaging.  For acquisition purposes, the packaging requirements shall be as specified in the contract or order (see 6.2).  When actual packaging of materiel is to be performed by DoD personnel, these personnel need to contact the responsible packaging activity to ascertain requisite packaging requirements.  Packaging requirements are maintained by the Inventory Control Point's packaging activity within the Military Department or Defense Agency, or within the Military Department's System Command.  Packaging data retrieval is available from the managing Military Department's or Defense Agency's automated packaging files, CD-ROM products, or by contacting the responsible packaging activity.

6.  NOTES

(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)

6.1  Intended use.  The relay is intended for use in Torpedo MK 37 Mod 2.

6.2  Acquisition requirements.  Acquisition documents must specify the following: (a)   Title, number, and date of the specification.

(b)   Issue of DoDISS to be cited in the solicitation, and if required, the specific issue of individual documents referenced (see 2.2.1).

(c)   Packaging requirements (see 5.1).

(d)   Assigned activity for preproduction and periodic production inspections. (e)   Data required other than that specified in 3.3.2.

(f)    That additional samples required because of failure of any unit(s) to pass the prescribed periodic production inspections will be provided and inspected at the expense of the supplier.

6.3  Inherent or latent defects.  When material which has been inspected, tested, and accepted contains inherent or latent defects subsequently exposed, the contractor may be required to replace the defective material without

expense to the Government.

6.4  Part or Identifying Number (PIN).  This specification requires a PIN that is as described in the appropriate reference to associated documents (see 3.1).

6.5  Subject term (key word) listing. Contact rating

Coil mounting

Drawing 1521140

6.6  Changes from previous issue.  Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extensiveness of the changes.

Custodians:                                                                                                                            Preparing activity: Navy - OS                                                                                                                              DLA - CC

DLA - CC

(Project 5945-1180)

13