MIL-PRF-6106/39F
Inches
mm
Inches
mm
Inches
mm
.001
0.03
.133
3.38
.425
10.80
.002
0.05
.140
3.56
.500
12.70
.003
0.08
.141
3.58
.640
16.26
.025
0.64
.150
3.81
.712
18.08
.031
0.79
.156
3.96
.810
20.57
.040
1.02
.170
4.32
.850
21.59
.050
1.27
.200
5.08
1.062
26.97
.075
1.91
.210
5.33
1.070
21.18
.110
2.79
.250
6.35
1.078
27.38
1.280
32.51
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Unless otherwise specified, tolerances are .010 (0.25 mm).
4. There shall be affixed to the relay a legible circuit diagram that identifies each terminal location specified.
5. These relays are polarized bistable.
6. This relay shall not operate or be damaged by reverse polarity. Semiconductors shall not be used for this
purpose.
7. Permanent magnet drive consists of a permanent magnet with its flux path switched and combined with the
electromagnetic flux.
8. Applicable to configuration B only. The circuit diagram, manufacturer's PIN, and the military PIN shall be
marked on the near side. The remaining portion of the nameplate data shall be marked on the far side.
9. Applicable to configuration B only. Relays shall be marked with the manufacturer's name or source code and
date code. In addition, ER relays shall be marked with the serial number. Marking shall be with the bottom of
the print adjacent to the near side.
10. Socket pin terminals shall provide the operational, environmental, and interface characteristics to provide a
reliable interconnect to gold-plated contacts. Terminals, except the polarizing pin, shall be gold plated. One
system for gold plating that may be used is ASTM B488, type 3, class 1.25 with a nickel underplate of 50 to 150
microinches thick. The gold plating system shall enable the product to meet the performance requirements of
this specification and shall be approved by the qualifying activity.
11. Gasket shall provide a reliable seal between the relay and mating socket that will meet the environmental,
operational, and interface requirements of the relay with the mating socket. The gasket shall have shore
hardness 25 5, thickness .050 .005. Gasket material according to SAE-AMS3332 has been considered
acceptable.
12. Indicated terminals shall be identified by a contrasting bead.
FIGURE 1. Dimensions and configurations - Continued.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business