MIL-DTL-83729/1E
REQUIREMENTS:
Contact data:
Single pole, double throw, break before make.
Polarity: With positive voltage on lead 6 and negative on lead 4, contacts 2 and 3 close.
Voltage and current: 2 milliamperes resistive maximum at 10 volts, 5,000 ohms resistance.
Resistance: Shall not exceed 10 ohms.
Contact bounce: Shall not exceed 15° during the initial or final 25° of dwell or maximum of 30° for any dwell
period.
Coil data at 25°C:
Voltage rated: See table I.
Resistance, dc: See table I.
Impedance: See table I.
Frequency range: See table I.
Waveform characteristics (6.3 volts, at 25°C):
Dwell time: See table I.
Dissymmetry: 30° maximum.
Transfer time: See table I.
Phase angle: See table I.
Noise level: Shall not exceed 30 µV rms.
Environmental conditions:
Temperature range: -65°C to +100° C.
Seal: Seal test I.
Dielectric withstanding voltage: See table I.
Insulation resistance: Shall be 100 megohms minimum at 100 V dc.
Vibration: Vibration I, method 201, MIL-STD-202, contact derangement 15° maximum.
Moisture resistance: At the completion of the sixth step, insulation resistance shall be 100 ohms minimum.
Shock: Method 213, MIL-STD-202, test condition I (100 g's).
Dielectric withstanding voltage: Not applicable.
Life:
Duration of test: 1,000 hours at nominal coil voltage and frequency with zero voltage on the contacts at 25°C.
Mechanical:
Weight: .021 pounds maximum, without hardware.
Dimensions: See figure 1.
Dissimilar metals: Not applicable.
Enclosure: Sealed.
Terminals: Wire leads.
Mounting position: Any.
Part or Identifying Number (PIN): M83729/1- (dash number from table I).
3