MS27742E
Inches .001 |
mm 0.02 |
.172 |
4.36 |
Inches .600 |
mm 15.24 |
|
.002 |
0.05 |
.218 |
5.53 |
.625 |
15.87 |
|
.003 |
0.07 |
.234 |
5.94 |
.630 |
16.00 |
|
.005 |
0.12 |
.250 |
6.35 |
.650 |
16.51 |
|
.020 |
0.50 |
.270 |
6.85 |
1.010 |
25.65 |
|
.040 |
1.01 |
.300 |
7.62 |
1.025 |
26.03 |
|
.050 |
1.27 |
.312 |
7.92 |
1.062 |
26.97 |
|
.062 |
1.57 |
.375 |
9.52 |
1.396 |
35.45 |
|
.093 |
2.36 |
.395 |
10.03 |
1.446 |
36.72 |
|
.150 |
3.81 |
.432 |
10.97 |
1.718 |
43.63 |
|
.156 |
3.96 |
.450 |
11.43 |
|||
NOTES: |
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Unless otherwise specified, tolerance is ±.010 (0.25 mm).
4. There shall be affixed to the relay a suitable legible circuit diagram that identifies each terminal location specified.
5. In the event of a conflict between the text of this specification and the references cited herein, the text of this
specification shall take precedence.
6. Referenced Government documents of the issue listed in that issue of the Department of Defense Index of specifications and standards (DoDISS) specified in the solicitation form a part of this specification to the extent specified herein.
7. Relay is magnetically latched in both positions.
8. Note to observe polarity must appear on relays.
9. X1 and X2 diameter .062 ±.001. Y1 and Y2 diameter .040 ±.001.
10. Coils are not to be energized simultaneously.
11. Socket pin terminals shall provide the operational, environmental, and interface characteristics to provide a reliable interconnect to gold-plated contacts. Terminals shall be gold plated. One system for gold plating that
may be used is ASTM 8488, type 3, class 1.25 with a nickel underplate of 50 to 150 microinches thick. The gold plating system shall enable the product to meet the performance requirements of this specification and shall be approved by the qualifying activity.
12. Gasket shall provide a reliable seal between the relay and mating socket that will meet the environmental, operational, and interface requirements of the relay with the mating socket. The gasket shall have shore hardness 20 ±5, thickness .050 ±.005. Gasket material according to AMS 3332 has been considered acceptable.
FIGURE 1. Dimensions and configurations - Continued.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business