MS27710D
NOTES:
1. All dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Unless otherwise specified, tolerance is ±.032 (0.81 mm).
4. The flasher need not have the contour shown, but shall be contained within the outline shown.
5. Case-enclosure may be completely potted or hermetically sealed. If the enclosure is hermetically sealed, it shall be tested in accordance with MIL-STD-202, method 112, test condition C, procedure IV. Maximum total leakage rate shall not exceed 1 micron cubic foot per hour per cubic inch sealed volume at a pressure differential of 1 atmosphere.
6. Life paragraph 4.5.14 of MIL-F-26301 applies. The test shall consist of 2500 hours of operation, during and at end of which the unit shall meet the flash rate specified herein.
7. Flasher shall conform to MIL-F-26301, type II, style I, class I, and as specified herein.
8. For design purposes, this specification sheet takes precedence over MIL-F-26301.
9. Referenced documents shall be of the issue in effect on date of invitation for bid.
10. First article testing shall be performed in accordance with MIL-F-26301.
FIGURE 1. Dimensions and configuration - Continued. REQUIREMENTS:
Input voltage: 20-30 V dc.
Output (contact rating): 2.5 amperes (lamp load at 28 V dc). Flash rate: 85 ±10 flashes per minute (FPM).
Life: 2500 hours.
Weight: 10 ounces maximum. Part number: MS27710-01.
Custodians: Preparing activity: Air Force - 11 DLA - CC
DLA - CC
Review activities: (Project 5945-1183) Air Force - 99
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business