MS27222M
Inches |
mm |
Inches |
mm |
Inches |
mm |
.010 |
0.25 |
.218 |
5.54 |
.812 |
20.62 |
.031 |
0.79 |
.250 |
6.35 |
1.156 |
29.36 |
.047 |
1.19 |
.254 |
6.45 |
1.812 |
46.02 |
.063 |
1.60 |
.297 |
7.54 |
2.170 |
55.12 |
.079 |
2.01 |
.328 |
8.33 |
2.190 |
55.63 |
.138 |
3.51 |
.391 |
9.93 |
2.687 |
68.25 |
.140 |
3.56 |
.438 |
11.13 |
3.250 |
82.55 |
.190 |
4.83 |
.625 |
15.88 |
3.337 |
84.76 |
.210 |
5.33 |
.656 |
16.66 |
3.734 |
94.84 |
.215 |
5.46 |
.750 |
19.05 |
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Unless otherwise specified, tolerance is ±.031 (0.79 mm).
4. Coil and auxiliary terminals may use additional washer for terminal seat.
5. In the event of a conflict between the text of this specification and the references cited herein, the text of this specification shall take precedence.
6. Referenced Government documents of the issue listed in that issue of the Department of Defense Index of
Specifications and Standards (DoDISS) specified in the solicitation forms a part of this standard to the extent
specified herein.
7. Terminal strength: High temperature pull and torque test not applicable.
8. When semiconductors are required, JANTX or equivalent screened semiconductors shall be used. Relays using suppression devices shall continue to operate should the suppression circuit be in a failure mode. Diodes shall have a peak inverse voltage of 600 V dc minimum.
9. For detail information, see tables I through V.
FIGURE 1. Dimensions and configurations - Continued.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business