MS25469 Relays, Electromagnetic, 5 Amperes, 6 Pdt, Type I, Magnetic Latch, Stud Mounted, Solder Hook Terminals, Hermetically Sealed

Pages 1 - 2 - 3 - 4 - 5

MS25469F

TABLE II.  Operating characteristics.

1/  CAUTION:  Use of any coil voltage less than rated coil voltage will compromise the operation of the relay.

2/  Over the temperature range.

3/  With rated coil voltage.

4/  From rated coil voltage.

5/  MS25469-A1 may be used on 60 Hz if maximum ambient temperature is limited to +85°C.  Maximum coil current shall be 0.077 ampere).

6/  MS25469-A1 is inactive for new design without replacement effective 30 September 1987.

NOTES

Referenced documents.  In addition to MIL-PRF-6106, this specification sheet references the following documents. (Government documents are available on line at https://assist.daps.dla.mil/quicksearch or www.dodssp.daps.mil or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094).

STANDARDS Department of Defense

MIL-STD-461     -      Requirements for the Control of  Electromagnetic Interference Characteristics of

Subsystems and Equipment

Custodians:                                                                                                    Preparing activity: Navy - AS                                                                                                       DLA - CC

Air Force - 11

DLA - CC                                                                                                    (Project 5945-1214-16)

Review activities: Navy - EC

NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using ASSIST Online database at www.dodssp.daps.mil.

5