MS25329 Relays, Electromagnetic, 6 Pdt, 5 Amperes, Type I, Socket Mounted, Hermetically Sealed

Pages 1 - 2 - 3 - 4 - 5 - 6

MS25329M

	Inches .001	mm 0.03	Inches .176	mm 4.47	Inches .704	mm 17.88
	.005	0.13	.203	5.16	.750	19.05
	.008	0.20	.221	5.61	.792	20.12
	.040	1.02	.304	7.72	.880	22.35
	.047	1.19	.344	8.74	1.500	38.10
	.062	1.57	.352	8.94	1.531	38.89
	.088	2.24	.375	9.53	1.812	46.02
	.093	2.36	.458	11.63	1.844	46.84
	.147	3.73	.528	13.41	2.187	55.55
	.152	3.86	.608	15.44
NOTES:

1. Dimensions are in inches.

2. Metric equivalents are given for general information only.

3. Unless otherwise specified, tolerance is ±.010 (0.25 mm).

4. Terminal numbers shall not appear on relay headers. There shall be affixed to the relay a suitable legible circuit diagram that positively and permanently identifies each terminal location diagram that positively and permanently identifies each terminal location specified herein.

5. The use of diodes on ac relays is optional. Actual application must be shown on label.

6. In the event of conflict between the text of this specification and the references cited herein, the text of this specification shall take precedence.

7. Referenced Government documents of the issue listed in that issue of the Department of Defense Index of Specifications and Standards (DODISS) specified in the solicitation form a part of this specification to the extent specified herein.

8. Pins to be perpendicular to header surface within one degree.

9. Socket pin terminals shall provide the operational, environmental, and interface characteristics to provide a reliable interconnect to gold-plated contacts. Terminals shall be gold plated. One system for gold plating that may be used is ASTM 8488, type 3, class 1.25 with a nickel underplate of 50 to 150 microinches thick. The gold plating system shall enable the product to meet the performance requirements of this specification and shall be

approved by the qualifying activity.

FIGURE 1. Dimensions and configurations - Continued.